DAB Esybox Serie Instructions Pour L'installation Et L'entretien page 62

Setup of the auxiliary digitali inputs IN1, IN2, IN3, IN4
This paragraph shows the functions and possible configurations of the inputs of the control unit, connected by wireless to the device, by means of the
parameters I1, I2, I3, I4. For the electrical connections refer to the control unit manual.
The inputs IN1..IN4 are all the same and all the functions can be associated with each of them. Parameters I1, I2, I3 and I4 are used to associate the
function required to the corresponding input (IN1, IN2, IN3 and IN4.).
Each function associated with the inputs is explained in greater detail below in this paragraph. Table 14 sums up the functions and the various
configurations. The factory configurations can be seen in Table 15.
Factory configurations of the digital inputs IN1, IN2, IN3, IN4
Input
1
2
3
4
Table summarising the possible configurations of the digital inputs IN1, IN2, IN3, IN4 and their operation
Value
0
1
2
3
4
5
6
7
General disabling of motor by external signal (NO) + Reset of resettable blocks
8
General disabling of motor by external signal (NC) + Reset of resettable blocks
9
10
11
12
13
Value
0 (disable)
0 (disable)
0 (disable)
0 (disable)
Function associated to input INx
Input functions disabled
Water lack from external float (NO)
Water lack from external float (NC)
Auxiliary setpoint Pi (NO) for the input used
Auxiliary setpoint Pi (NC) for the input used
General disabling of motor by external signal (NO)
General disabling of motor by external signal (NC)
Reset of resettable blocks NO
Low pressure signal input NO, automatic and manual reset
Low pressure signal input NC, automatic and manual reset
Low pressure input NO only manual reset
Low pressure input NC only manual reset
ENGLISH
Table 14: Factory configurations of the inputs
Table 15: Configurations of the digital inputs
60
Display of the active function
associated with the input
Float switch symbol (F1)
Float switch symbol (F1)
Px
Px
F3
F3
F3
F3
F4
F4
F4
F4