DAB Esybox Serie Instructions Pour L'installation Et L'entretien page 53

Power histogram
Multi-pump
Output flow meter
Information HW and SW
Fault & Warning (Log)
Identifying colours
Modification of parameters in multi-pump assemblies
Set of sensitive parameters. These parameters must be aligned so that the multi-pump system can start. The modification of one of
these on any devices results in automatic alignment on all the other devices without any question.
Parameters of which the alignment is allowed in facilitated mode by only one device, broadcasting it to all the others. It is tolerated that
they may be different from one device to another.
Read-only parameters.
8.2 Access by name with a drop-down menu
The selection of the various menus is accessed by name. From the main menu you access menu selection by pressing either of the + or – keys.
The names of the menus that can be accessed appear on the menu selection page and one of the menus is highlighted by a bar (see Figure 14).
Shift the highlighting bar using the + and – keys to select the menu you want and enter it by pressing MODE.
Figure 14: Selection
of the drop-down
PI
system
VE
FF
The items available are MAIN, USER, MONITOR, followed by a fourth item, EXTENDED MENU; this item allows
the number of menus displayed to be extended. When EXTENDED MENU is selected a pop-up appears asking
you to type in an access key (PASSWORD). The access key (PASSWORD) coincides with the combination of keys
used for direct access (as in Table 8) and allows the extended display of the menus from the menu corresponding
to the access key to all those with a lower priority.
The order of the menus is: User, Manual Setpoint, Manual, Installer, Technical Assistance.
When an access key is selected, the menus released remain available for 15 minutes or until they are disabled
manually by means of the item "Hide forward menus" which appears on the menu selection when using an
access key. Figure 14 shows an operating diagram for selecting the menus. The menus are in the centre of the
page, from the right you reach them by means of direct selection with a combination of keys, while from the left
you reach them by means of the selection system with drop-down menu.
ENGLISH
Key
Modification of parameters in multi-pump assemblies
Table 9: Menu structure
51
temperature PR
Remote pressure
sensor
RM
Maximum speed
NA
Active devices
NC
Max. simultaneous
devices
IC
Device configuration
ET
Max. switching time
AY
Anti Cycling
AE
Anti-blocking
AF
AntiFreeze
I1
Function input 1
I2
Function input 2
I3
Function input 3
I4
Function input 4
O1
Function output 1
O2
Function output 2
FW
Firmware
update
RF
Reset faults and
warnings
PW
Modify Password