8.3 Structure of the menu pages
When switched on, some presentation pages are displayed showing the name of the product and the logo, after which the main menu appears.
The name of each menu, whichever it may be, is always at the top of the display.
The following always appear on the main page:
– Status: operating status (e.g. standby, go, Fault, input functions)
– Revs per minute: value in [rpm]
– Pressure: value in [bar] or [psi] depending on the set unit of measure.
– Power: value in [kW] of the power absorbed by the device.
If the case occurs the following may appear:
– Fault indications
– Warning indications
–
Indications of the functions associated with the inputs
–
Specific icons
The error conditions are indicated in Table 4. The other displays are indicated in Table 10.
Identifying code
Com. icon with number
Com. icon with E
Low voltage
Figure 15: Diagram of possible menu accesses
Error or status conditions shown on the main page
GO
Motor running
SB
Motor stopped
DIS
Motor status manually disabled
F1
Float function status / alarm
F3
System disable function status / alarm
F4
Low pressure signal function status / alarm
P1
Operating status with auxiliary setpoint 1
P2
Operating status with auxiliary setpoint 2
P3
Operating status with auxiliary setpoint 3
P4
Operating status with auxiliary setpoint 4
Operating status in multi-pump communication with the address indicated
Error status of communication in the multi-pump system
EE
Writing and reading the factory settings on EEprom
WARN.
Warning due to lack of supply voltage
Table 10: Status and error messages on the main page
The other menu pages vary with the associated functions and are described later by type of indication or setting.
Once you have entered any menu, the bottom of the page always shows a summary of the main operating
parameters (running status or any fault, current speed and pressure). This allows a constant view of the
machine's fundamental parameters.
Figure 16: Display of a menu parameter
ENGLISH
Description
52