Unloading The Cot From A Vehicle With Two Operators - Powered Method - Stryker Power-PRO XT 6500 Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 99
English

UNlOADING ThE COT FROM A VEhIClE WITh TWO OPERATORS - POWERED METhOD

Unloading the cot from the vehicle while a patient is on
the cot requires a minimum of two (2) trained operators,
positioned at each end of the cot. Each operator must
grasp the cot frame securely.
WARNING
To avoid injury, verify that the safety bar has engaged
the safety hook before removing the cot from the
patient compartment.
Do not pull or lift on the safety bar when unloading the
cot. Damage to the safety bar could result and injury
to the patient or operator could occur.
Ensure proper hand placement on hand grips. Hands
should be clear of red safety bar pivots while loading
and unloading the cot.
Do not press the extend (+) button until the safety bar
has engaged the safety hook.
To unload the cot from a vehicle with two operators:
1.
Lift the vehicle bumper to the raised position (if
equipped).
2.
Disengage the cot from the cot fastener. (For more
information about the cot fastener, see
3. Operator 1 − Grasp the cot frame at the foot end. Pull
the cot out of the patient compartment until the safety
bar engages the safety hook as shown in Figure 20.
4. Operator 2 - Verify that the bar engages the safety
hook.
5. Operator 2 − Stabilize the cot during the unloading
operation by securely grasping the outer rail.
6. Operator 1 − Depress the extend (+) button to lower
the undercarriage to its fully extended position as
shown in Figure 21.
7.
Operator 2 − Pull the safety bar release lever forward
to disengage the safety bar from the safety hook in the
patient compartment as shown in Figure 22.
8.
Remove the load wheels from the patient compartment
of the vehicle.
CAUTION
When unloading the cot from the patient compartment,
ensure that the caster wheels are safely set on the
ground or damage to the product may occur.
Do not "jog" the cot past the load height while the
safety bar is engaged.
Return To Table of Contents
1-36
Operation Guide
Figure 20: 2 Operators Unloading the Cot
page
1-25).
Figure 21: 2 Operators - One Pressing the Extend
Figure 22: Disengaging the Safety Bar
6500-109-005 REV A
Button
www.stryker.com

Publicité

Table des Matières
loading

Table des Matières