Installing The Head End Storage Flat - Stryker Power-PRO XT 6500 Manuel D'utilisation Et D'entretien

INSTAllING ThE hEAD END STORAGE FlAT

To install the optional head end storage flat (see Figure 54):
1. Install the Velcro straps (A) near the pneumatic cylinder and around the cross bar of the retractable head section.
®
2. Buckle the restraint straps (B) around the outer rails of the retractable head section.
B
Cross Bar
WARNING
When the optional head end storage flat is being used, ensure that it does not interfere with the operation of the
retractable head section, safety bar and safety hook. Injury to the patient or operator could result.
CAUTION
• Do not store items under the cot mattress. Storing items under the mattress can interfere with the operation of
the cot.
• The weight of the equipment in the head end storage flat (if equipped) must not exceed 40 pounds (18 kg).
www.stryker.com
Optional Accessories
A
A
Figure 54: head End Storage Flat
6500-109-005 REV A
B
V-Tube
Return To Table of Contents
English
1-63