Unloading An Empty Cot From A Vehicle With One Operator - Manual Method - Stryker Power-PRO XT 6500 Manuel D'utilisation Et D'entretien

UNlOADING AN EMPTy COT FROM A VEhIClE WITh ONE OPERATOR - MANUAl METhOD

Unloading an unoccupied cot from a vehicle can be
accomplished by a single operator.
WARNING
• The one person loading and unloading procedures
are for use only with an empty cot. Do not use the
procedures when loading or unloading a patient. Injury
to the patient or operator could result.
• Do not pull or lift on the safety bar when unloading the
cot. Damage to the safety bar could result and injury
to the patient or operator could occur.
• Ensure proper hand placement on hand grips. Hands
should be clear of red safety bar pivots while loading
and unloading the cot.
To unload an empty cot from a vehicle with one
operator:
1. Lift the vehicle bumper to the raised position (if
equipped).
2. Disengage the cot from the cot fastener. (For more
information about the cot fastener, see
3. Grasp the cot frame at the foot end.
4. Pull the cot from the vehicle until the safety bar
engages the safety hook as shown in Figure 33.
5. Pull the manual back-up release handle to lower the
undercarriage to its fully extended position as shown
in Figure 34.
6. Disengage the safety bar from the safety hook by
pulling the safety bar release lever forward and roll the
cot out of the vehicle as shown in Figure 35.
7. Remove the load wheels from the patient compartment
of the vehicle.
CAUTION
When unloading the cot from the patient compartment,
ensure that the caster wheels are safely set on the ground
or damage to the product may occur.
www.stryker.com
Operation Guide
Figure 33: Pull the Cot out of the Vehicle
page 1-25).
Figure 34: Pull the Manual Back-up Release handle
Figure 35: Roll the Cot out of the Vehicle
6500-109-005 REV A
Return To Table of Contents
1-41
English