Removing The Battery From The Cot; Reinstalling Or Replacing The Battery - Stryker SMRT Power System 6500 Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49

REMOVING THE BATTERY FROM THE COT

English
To remove the SMRT Pak from the Power-PRO cot:
1.
Press the RED one hand release button or push the battery release button
to release the SMRT Pak from the cot as shown in Figure 9.
2.
Slide the released SMRT Pak out of the enclosure.
Battery
Release
Button

REINSTALLING OR REPLACING THE BATTERY

Note: To maximize available battery power, only use SMRT Paks that have been
fully charged within the last 48 hours.
To reinstall or replace the SMRT Pak into the Power-PRO cot:
1.
Align the tabs in the battery enclosure.
2.
Push the SMRT Pak into the enclosure until the latch clicks into place.
• The cot indicator LED is solid green if the SMRT Pak is fully charged
and ready.
• The cot indicator LED flashes amber if the SMRT Pak needs to be
recharged or replaced.
Return To Table of Contents
1-24
Battery Operation
Figure 9: SMRT Pak Removal and Replacement
6500-109-105 REV A
Slide to
Release
SMRT
Pak
One
Hand
Release
Button
www.stryker.com

Publicité

Table des Matières
loading

Table des Matières