Unloading An Empty Cot From A Vehicle With One Operator - Powered Method - Stryker Power-PRO XT 6500 Manuel D'utilisation Et D'entretien

UNlOADING AN EMPTy COT FROM A VEhIClE WITh ONE OPERATOR - POWERED METhOD

Unloading an unoccupied cot from a vehicle can be
accomplished by a single operator.
WARNING
• The one person loading and unloading procedures
are for use only with an empty cot. Do not use the
procedures when loading or unloading a patient. Injury
to the patient or operator could result.
• Do not pull or lift on the safety bar when unloading the
cot. Damage to the safety bar could result and injury
to the patient or operator could occur.
• Ensure proper hand placement on hand grips. Hands
should be clear of red safety bar pivots while loading
and unloading the cot.
To unload an empty cot from a vehicle with one
operator:
1. Lift the vehicle bumper to the raised position (if
equipped).
2. Disengage the cot from the cot fastener. (For more
information about the cot fastener, see
3. Grasp the cot frame at the foot end.
4. Pull the cot from the vehicle until the safety bar
engages the safety hook as shown in Figure 23.
5. Depress the extend (+) button to lower the undercarriage
to its fully extended position as shown in Figure 24.
6. Disengage the safety bar from the safety hook by
pulling the safety bar release lever forward and roll the
cot out of the vehicle as shown in Figure 25.
7. Remove the load wheels from the patient compartment
of the vehicle.
CAUTION
• When unloading the cot from the patient compartment,
ensure that the caster wheels are safely set on the
ground or damage to the product may occur.
• Do not "jog" the cot past the load height while the
safety bar is engaged.
www.stryker.com
Operation Guide
Figure 23: Pull the Cot out of the Vehicle
page 1-25).
Figure 24: Press the Extend Button
Figure 25: Roll the Cot out of the Vehicle
6500-109-005 REV A
Return To Table of Contents
1-37
English