Operating The Optional 3-Stage I.v. Pole - Stryker Power-PRO XT 6500 Manuel D'utilisation Et D'entretien

English

OPERATING ThE OPTIONAl 3-STAGE I.V. POlE

To use the 3-stage I.V. pole (see Figure 49.2):
1. Lift and pivot the pole from the storage position and push down
until it is locked into the receptacle (A).
2. To raise the height of the pole, turn the lock actuator (B)
counterclockwise and pull up on the bottom telescoping portion
(C) of the pole to raise it to the desired height.
3. Turn the lock actuator (B) clockwise to lock the bottom telescoping
portion in place.
4. For a higher I.V. pole, pull up on section (D) until the spring clip
(E) engages.
5. Hang I.V. bags on the I.V. hook (F).
6. To lower the I.V. pole, push in on the spring clip (E) and slide
section (D) down into section (C). Turn the lock actuator (B)
counterclockwise and slide section (C) into the bottom tube.
7. Turn the lock actuator (B) clockwise to tighten.
8. Lift up and pivot the pole down into the storage position (see
Figure 49.1).
CAUTION
To avoid damage to the I.V. pole, the weight of the I.V. bags or equipment
must not exceed 40 pounds (18 kg).
Figure 49.1: 3-Stage I.V. Pole Storage Position
Return To Table of Contents
1-56
Operation Guide
6500-109-005 REV A
F
F
D
D
E
E
C
C
B
B
A
A
Figure 49.2: 3-Stage I.V. Pole
www.stryker.com