Keys Function" Function - ModelCraft GT4 Notice D'emploi

The timer continues to operate even when the set time has been counted down. In this case, the product
automatically switches into "Up timer" mode.
In this case, a short signal sounds after the end of the set time if the sound is activated (see menu item
„Systems").
Times between 1 minute and 99 minutes can be set.
"Lap timer":
This mode allows you save a specifi c lap time.
Tap the "Start" button to start timing. Then, tap the "Lap" button to save a lap time. To stop timing, tap the "Reset"
button.
After each activation of the "Lap" button, the current lap time is displayed in the LC display for about 3
seconds and then saved. During this time, the timer continues to operate normally.
"Lap memory":
This mode shows all saved lap times. You can save a maximum of 100 lap times.
Tapping the timer type shown in the display (xx Timer) opens a submenu in which the desired timer type can be
selected.
u) "Keys function" function
This function enables you to assign functions for the individual
trim buttons.
Tap the trim button to assign a given function to it. This will open
a menu. From the menu, select from the available functions. Tap
the "Back" button to save the new values and return to the previ-
ous menu.
Switchable functions can be assigned in any submenu of the
switches (e.g. „SW1 to SW3") or trimmer (TR1 to TR5). You
need to scroll the display content for overview. The main display
shows the corresponding icon with the function activated.
Figure 32
81