Checking And Setting The Dual Rate Function For Steering - ModelCraft GT3.2 Notice D'emploi

Middle position of the drive function
Using the "TH TR" trimming button (see Figure 2, Number 3) for the drive function, set the middle position for the ac-
celerator servo. Press the button briefly to switch to "TRIM display" mode. Turn the programming setting wheel (see
Figure 3, Number 14) to increase or decrease the set value. The trim value that may be set lies between Forwards
(F 30) and Backwards (B 30).
When the display is at (N 00), the precise middle position has been reached. Push the programming setting wheel for
the display (see Figure 3, Number 14) to save the value. Then, press the „Return" button (see Figure 3, Number 10)
to switch back to the operating display.
Also set the middle value precisely if you are using an electronic cruise control in place of a accelerator
servo.
c) Checking and setting the dual rate function for steering
With the "D/R" button for the steering function (see Figure 2, Number
2) you can reduce the maximum steering end point electronically. To
set the steering rods in the model, it is first necessary to set the maxi-
mum possible steering end point of 100% or to check the setting.
If you press the button briefly, the display switches from operating
display to "D/R display".
Moving the button in both directions enables you to increase or de-
creases the value. Operate and hold the button, to constantly change
the set value. The value that may be set lies between 0 and 100%.
When the display is at 100%, the maximum steering end point is pos-
sible. Push the programming setting wheel for the display (see Fig-
ure 3, Number 14) to save the value. Then, press the „Return" button
(see Figure 3, Number 10) to switch back to the operating display.
D/R
Dual rate
CHANNEL:
100%
Figure 6
43