Steering Mix" Function - ModelCraft GT4 Notice D'emploi

g) "Steering mix" function
This function allows you to set four different types of steering
on your model.
"Front side":
Only the front wheel steering is controlled.
"Rear side":
Only the rear wheel steering is controlled.
"Same Phase":
Front and rear wheels are controlled in the same way.
"Rev. Phase":
Front and rear wheels are controlled in the opposite way.
Select the parameter to be changed in order to set the required
steering type. Tap the "Back" button to save the new values and
return to the previous menu.
Note:
If you select the function „Front side" or „Rear Side", a steering
servo that is connected to the receiver at CH1 is triggered.
Figure 17
Use the function „Same phase" or „Rev.phase" to trigger two
steering servos at once with the steering movement at the transmitter. Steering servo 1 is connected to CH1, steering
servo 2 to CH3. In this case, the control button has no function at the transmitter for CH3.
The control characteristics for both steering servos can be set individually (CH1 and CH3) in the menu items „Reverse,
End points and Subtrim". For the functions „Steering exponential and Steering speed", the settings of CH1 serve as
master and control the CH3 (slave) automatically for the set value 1:1.
71