Brake Mixing" Function; Mixes" Function - ModelCraft GT4 Notice D'emploi

q) "Brake mixing" function
This function enables you to control the brakes using two or
three independent servos. The Channels 3 (CH3) or 4 (CH4) are
used as slave channels for the accelerator/brake servo, whereby
only the braking function has an infl uence on the slave channels.
After activating one of the two channels, you can set the A.B.S.
as well as the exponential function of the accelerator/brake servo
for this channel individually.
Note:
Since up to three servos can be activated for a brake function,
you have many options for programming, e.g., a kind of „Brake
force distributor". Due to the many options, we cannot provide
any more specifi c indication for programming in these operating
instructions.
Select the parameter to be changed. Slide the regulator to the
right or left to change the value to suit your requirements. Tap
the "Back" button to save the new values and return to the previ-
ous menu.
r) "Mixes" function
This function allows you to control two servos at the same time.
The electronic proportion of the main channel (Master) is mixed
to a further channel (Slave) to do this. You can set the direction
individually. You can mix between all four channels.
Select a parameter to be mixed. Select the "Activate/Deactivate"
button. Slide the regulator to the right or left to change the value
to suit your requirements. Tap the "Back" button to save the new
values and return to the previous menu. Tap the "Activate/Deac-
tivate" button to deactivate the set value.
78
Figure 27
Figure 28