Charging The Lipo Battery Pack - ModelCraft GT4 Notice D'emploi

8. Charging the LiPo battery pack

In subsequent sections of the instructions, the numbers in the text refer always to the neighbouring Figure
or to the Figures within the section. Cross-references to other Figures will be specifi ed along with the
appropriate Figure number.
The LiPo battery pack required for the remote control is generally included in the scope of delivery and must be
charged.
Caution, important note!
The supplied LiPo battery pack may only be charged in the transmitter. Never use another charger to
charge the LiPo battery pack.
The charging current of the LiPo battery pack may exceed 500 mA, for this reason, charging connected to
the USB port of a computer is not permitted.
Inserting and charging the LiPo battery pack
The lid of the battery compartment (14) is located on the
underside of the transmitter. Press on the corrugated
surface and slide the lid off. Then, insert the LiPo bat-
tery pack. Slide the battery compartment lid (14) back
over the compartment. The lid must click audibly into
place
Connect a Micro-USB cable (X) to the Micro-USB port
(12) of the transmitter. Connect the other end of the
Micro-USB cable (X) to a pluggable power supply with
a USB port. Only charge the supplied LiPo battery pack
in the transmitter, never use another battery pack.
The LiPo battery pack is fully charged when the symbol
of the status display of the transmitter battery pack (see
Figure 10, Number 3) is completely green when the
transmitter is switched on.
Status display for transmitter battery pack/receiver battery pack
Battery pack is being charged
Battery pack is fully charged
12
X
14
Figure 1
53