ModelCraft GT4 Notice D'emploi page 79

Figure 29
"Master channel":
Here, you select the Master channel.
"Slave channel":
Here, you select the Slave channel.
"Low side mix":
The infl uence of the "Left servo control device" of the master channel on the slave channel is determined.
If you set 0% or a positive percentage, the slave channel is not triggered when the "High side mix" is deactivated.
The settings for "Low side mix" and "High side mix" infl uence each other with the "High side mix" activated. The slave
servo would not be triggered with a setting Low side mix = 100 and High side mix = -100, since the two set values will
balance each other out.
"High side mix":
The infl uence of the „Right servo control device" of the master channel on the slave channel is determined.
If you set 0% or a negative percentage, the slave channel is not triggered when the „Low side mix" is deactivated.
The settings for „Low side mix" and „High side mix" infl uence each other with the „High side mix" activated. The slave
servo would not be triggered with a setting Low side mix = 100 and High side mix = -100, since the two set values will
balance each other out.
"Offset":
Here, you introduce an Offset value to the Slave channel. A negative value pushes the Slave channel to its smallest
point.
79