Throttle Exponential" Function; Throttle Curve" Function - ModelCraft GT4 Notice D'emploi

i) "Throttle exponential" function
This function enables you to infl uence the sensitivity of the ac-
celerator/brake servo. In doing so, the linear path between the
controller and the servo is modifi ed to a non-linear (exponential)
path. A more sensitive control about the neutral position is thus
possible. The maximum control path is not modifi ed when doing
this.
"Exp.":
The value that can be set for this function is -100 % to 100 %,
whereby the value 0 % corresponds to linear control. A modifi ca-
tion of the set value always affects both sides of the servo end
point equally.
Note:
Negative values increase the servo defl ection around the centre
position.
"Rate":
Here, the angle of the curve is set. The value that can be set for
the angle of the curved is 0 % to 100 %. The lower the value set,
the lower the servo defl ection.
Select the "Activate" button. Then, select the parameter to be
changed. Slide the regulator to the right or left to change the value to suit your requirements. Select the "Activate"
button to save the current value. Tap the "Back" button to return to the previous menu.
j) "Throttle curve" function
This function enables you to adapt the acceleration acceptance
behaviour of the accelerator/brake servo in a 5-point curve. Each
individual point can be adapted individually. Values from -100 %
to 100 % may be set.
Select the "Activate" button. Then, select the parameter to be
changed. Slide the regulator to the right or left to change the
value to suit your requirements. Select the "Activate" button to
save the current value. Tap the "Back" button to return to the
previous menu.
Figure 19
Figure 20
73