Engine Cut" Function; Boat Mode" Function - ModelCraft GT4 Notice D'emploi

o) "Engine cut" function
This function is used to ignore the position of the accelerator/
brake lever of the remote control and set the accelerator/brake
servo to a predefi ned position.
Select the "Activate" button. Slide the regulator to the right or left
to change the value to suit your requirements. Select the "Acti-
vate" button to save the current value. Tap the "Back" button to
return to the previous menu. A desired switch (e.g. SW1 to SW3)
must be assigned for the „Engine cut" function. This is done in
the „Keys Function".
Note:
Any switchable function can be assigned in any submenu of the
switches (e.g. „SW1 to SW3"). You need to scroll the display
content for overview. The display shows the corresponding icon
with the function activated.
p) "Boat mode" function
This function permits moving the throttle lever along the entire
servo path from the neutral position. A brake function therefore
is not intended for.
With the function activated, the throttle servo (or the electronic
speed controller) is set to the end stop with the throttle lever of
the transmitter in the neutral position (motor off). Now move the
throttle lever of the transmitter towards full throttle (the lever is
pulled towards the grip), the servo (or the electronic speed cont-
roller) will move towards full throttle. If the throttle lever is pulled
completely towards the grip, the other end stop is reached.
Figure 25
Figure 26
77