Display Servos" Function; Race Timer" Function - ModelCraft GT4 Notice D'emploi

s) "Display servos" function
This function shows you real-time information regarding the posi-
tion of all four servo levers. For this, move the control elements
of the transmitter (e.g. the steering wheel).
Click the icon "Servo lever" next to the green "Return arrow" to
activate a "Servo tester". All the connected servos for the set
values (end points, rotating directions, etc.) are moved automati-
cally. The display for this is according to the movement of the
servos at the display.
Figure 30
t) "Race timer" function
This function allows you to set the timer function in four different
modes. Tap "Mode" to switch between the four different modes.
The following modes are available for use:
"Up timer":
The mode starts the timer and ends only when the "Stop" button
is tapped.
Tap the "Start" button to start timing. Then, tap the "Stop" button
to stop timing. To reset the counter back to "0", tap the "Reset"
button.
"Down timer":
This mode allows you to count down from a individually set time.
Slide the regulator to the left or right to set a particular time. The
set time intervals are adjusted by a minute each. Tap the "Start"
button to start timing. Then, tap the "Stop" button to stop timing.
To reset the counter back to "0", tap the "Reset" button.
Figure 31
80