Rx Setup" Function - ModelCraft GT4 Notice D'emploi

w) "RX setup" function
This function enables you to programme the receiver. The follow-
ing setting options are available for use:
"Bind with a receiver":
Select this function if the transmitter is to be bound to a receiver
again.
"RX battery monitor":
This function shows you the following information regarding the
receiver battery pack/receiver battery:
"External sensor":
Activate this function if you are using an external sensor. This
is particularly useful if the receiver is supplied via an electronic
drive regulator with power. To do this, connect the sensor directly
to the main battery.
"Low voltage":
Set the minimum voltage for an almost discharged battery pack.
"Alarm voltage":
Figure 34
Set the time from which onward the transmitter is to issue an
alarm when a specifi c voltage is undercut.
"High voltage":
Set the maximum voltage for a completely charged battery pack.
Select the parameter to be changed. Slide the regulator to the right or left to change the value to suit your require-
ments. Tap the "Back" button to save the new values and return to the previous menu.
"Failsafe":
This function permits programming of the servo items that are automatically set when the receiver signal is lost. When
the settings are set to "Off", the servos remain in their last position when the signal is lost.
This is how you change the values of the individual servo positions:
Activate "Steering":
Tap the "Activate/Deactivate" button. Turn the control wheel for the steering function to the left or right and hold the
desired position. Tap the "Back" button to save the new values and return to the previous menu.
Deactivate "Steering":
Select the "Steering" function. Tap the "Activate/Deactivate" button to deactivate the set value.
The values set with the transmitter encoders (e.g. steering wheel) for the failsafe function are displayed in the display
of the function „Failsafe" when the function is activated. If a programmed failsafe value is deactivated, the set value is
permanently deleted and needs to be re-set when the failsafe function is activated.
83