ModelCraft GT4 Notice D'emploi page 84

Activate "Throttle":
Tap the "Activate/Deactivate" button. Pull the accelerator/brake lever forwards or backwards and hold the desired
position. Tap the "Back" button to save the new values and return to the previous menu.
Deactivate "Throttle":
Select the "Throttle" function. Tap the "Activate/Deactivate" button to deactivate the set value.
"Display sensors":
This function shows you all the information regarding all connected sensors.
"Choose sensors":
This function shows you all the information regarding up to four sensors on the main screen. Tap the parameter and
select the desired sensor.
"Speed and distance":
This function enables you to programme a rotation counter or an odometer connected to the receiver.
Tap the "Speed sensor" function to select a rotation counter. "None" means that none has been selected.
Tap the "Set rotation length" function to set the circumference of the tyre that the rotation counter is connected to.
Tap "Reset odometer 1" or "Reset odometer 2", to reset the virtual odometer back to "0".
"Servo setup":
This function could trigger servos with serial interfaces. Special servos required for the transmitter system are required
for this. Therefore, this function is currently deactivated.
"Servos frequency":
Servos are triggered in a certain rhythm (frame rate) with control signals. The standard frequency is 50 Hz. Special,
usually digital servos, require a higher control rate. Select the matching frequency according to the notes of the servo
manufacturer.
Note:
A change of the control frequency affects all control elements connected to the receiver (e.g. speed controller, servos,
etc.).
If control elements that are only designed for a trigger frequency of 50 Hz are triggered at a higher frequency, they
may be destroyed.
84