Connecting A Rotation Sensor; Temperature Sensor; Voltage Sensor; Speed Sensor - ModelCraft GT4 Notice D'emploi

12. Connecting a rotation sensor

a) Programming the Remote Control
Three sensors are included in the delivery of the remote control that can record a temperature, a voltage and a speed.
Up to 15 sensors can be connected to the receiver in series and displayed in different constellations in the transmitter.
b) Temperature sensor
The temperature sensor „STM01" can measure, e.g., the temperature of a speed battery in the range of -40° to 100°C
and transmit it to the transmitter by telemetrics. For this, attach the temperature sensor that is installed to the sensor
housing in a suitable location, e.g. with a rubber band or adhesive tape.
c) Voltage Sensor
The voltage sensor „SVT01" can measure, e.g., the voltage of a speed battery in the range of 4.0 to 30.0 Volt and
transmit it to the transmitter by telemetrics. Plug the connection cable, which is installed to the voltage sensor, to the
speed battery with the correct polarity (e.g. to the balancer connection). The red cable must be connected to the plus,
the black to the minus pole of the rechargeable battery. Avoid short circuits and polarity reversal since this may cause
damage.
d) Speed Sensor
The speed sensor „SPD01" can measure, e.g., the
speed in the range of 0 to 16,000 U/min and transmit it
to the transmitter by telemetrics. At the transmitter, you
can display the speed of the drive wheel. Additionally,
you can display the distance driven (menu item odome-
ter) and/or the speed driven (menu item Speed) with the
corresponding settings at the transmitter.
To install the speed sensor, you need to attach a mag-
net (fi gure 7a, item 2) to the rotating part (e.g. a wheel
rim – fi gure 7a, item 1) so that the sensor of the speed
sensor (fi g. 7a, item 3) can slide past at a distance of
less than or equal to 2 mm. Assembly material required
for this (suitable glue for the magnet or, e.g., cable ties
for the sensor attachment) are not enclosed with the
remote control and must be purchased separately.
60
2
1
3
3
N
S
2
Figure 7a