Programming The Remote Control - ModelCraft GT4 Notice D'emploi

14. Programming the remote control

a) Programming the remote control
This product enables you to coordinate the drive, steering and switching functions of your model individually and to
permanently store the set values. Only a model set to suit the given driver will offer the most fun.
Information is entered into the product via the touchscreen display. As soon as you switch on the product, the following
information will be shown on the LC display.
1. Receiving strength of the receiver
2. Memory number and model name
3. Status display for the transmitter battery pack
4. Status display for the receiver batteries/battery
pack
5. RX - display fi eld of the sensors
6. Icon bar of the active mixer
7. TX - display of the servo paths and trims
8. Help - menu (in the English language)
9. Main menu
Notes:
Ad 1. : The receiver strength of the receiver is permanently transferred to the transmitter by telemetrics and displayed
Ad 5.: Up to four measured values of sensors can be displayed in the display fi elds „RX". The display values are
selected in the menu „RX setup".
Ad 6.: Activated mixers or functions are displayed in the icon list.
Ad 7.: The display fi eld „TX" permits tracking all servo paths by bar display. You can also see the current settings for
trimming of the throttle (F / B) or steering (L / R).
64
2
1
5
6
7
8
3
4
9
Figure 10