System" Function - ModelCraft GT4 Notice D'emploi

x) "System" function
This menu allows you to make various settings for your product.
"Backlight timeout":
Here you set the length of time for the backlighting of the LC
display when it is no longer being touched.
"Backlight":
Here, you can set the brightness of the backlight for the LC dis-
play. A higher value ensures better recognition of the LC display
but also causes faster discharge of the battery pack.
"Sound":
Here you can activate or deactivate the loudspeakers of the
product.
If you deactivate the loudspeakers, the product no
longer gives out warning signals, for example, in the
event of too low a battery voltage.
"Auto power off":
When you do not use the product for about fi ve minutes, an acoustic signal is sounded. After a further fi ve minutes,
the product switches itself off automatically. Check this box to activate this function.
"Screen calibrate":
Here you can re-calibrate the screen display on the LC display. Click every displayed "X" at the display for this.
„Units":
Use this menu item to select the dimensional units for the length „metric = mm" or „imperial = inch". For „Temperature",
you can choose between degrees Celsius or degrees Fahrenheit.
„USB function":
The basic setting in this menu is „none". This means that the transmitter can be charged at a computer or USB plug-in
mains adapter via the USB connection cable. If you select the USB function „FS-iT4 emulator", the transmitter can be
used for common drive simulators. Proceed in the following sequence
• Connect the USB cable from the delivery to the socket at the transmitter fi rst and then to a free USB port of your
computer.
• Now switch on the transmitter.
• Select the submenu „USB function" in the menu „System" and select the function „FS-iT4 emulator".
• Your computer will display the message „New USB device" and „Device drivers installed successfully" after a brief
time.
• Find the folder „Devices and printers" on your computer. Now you can view the icon „FS-iT4 emulator" here. Activate
the device driver by double-clicking the ICON.
Figure 35
85