Throttle Middle Position" Function; Throttle Idle Up" Function - ModelCraft GT4 Notice D'emploi

m) "Throttle middle position" function
This function permits changing the servo adjustment path
starting in the neutral position of the throttle lever.
The example shown in fi gure 23 would move the throttle servo
(or the electronic speed controller) by 60% of the servo control
path if the throttle lever at the transmitter is moved from the neu-
tral position towards full throttle. If you move the throttle lever at
the transmitter from the neutral position towards the brake, the
throttle lever would only move by 40% of the servo control path.
Slide the regulator to the right or left to adjust the value. Tap the
"Back" button to save the new values and return to the previous
menu.
Figure 23
n) "Throttle idle up" function
This function enables you to adjust the neutral position of the ac-
celerator/brake servo. This can be particularly useful when you
are operating a petrol-powered model. This enables you to raise
the idle revolutions when the engine has not yet warmed up.
Select the "Activate/Deactivate" button. Slide the regulator to the
right or left to change the value to suit your requirements. Tap the
"Back" button to save the new values and return to the previous
menu. Tap the "Activate/Deactivate" button to deactivate the set
value. A desired switch (e.g. SW1 to SW3) must be assigned for
the "Idle up" function. This is done in the "Keys Function".
Note:
Any switchable function can be assigned in any submenu of the
switches „Keys function" (e.g. „SW1 to SW3"). You need to scroll
the display content for overview. The display shows the corres-
ponding icon with the function activated.
Figure 24
76