Starting Up The Transmitter; Switching On The Transmitter; Checking And Setting The Digital Trimming - ModelCraft GT4 Notice D'emploi

10. Starting up the transmitter

a) Switching on the transmitter
For testing purposes, switch the transmitter on using the On/Off switch (see Figure 2, Number 7). The display is made
visible by the backlighting now. To save battery capacity, the backlighting is automatically dimmed after a while. The
backlighting can be activated again by touching the display. Brightness settings and setting of the time until dimming
of the backlighting are explained in chapter "Settings in the Main Menu / System".
Push the on/off switch again to deactivate the transmitter. It must be pushed for about three seconds.
Note:
When the submenu "Sound" is activated in the menu "System", not only warning signals for different warning condi-
tions but also a sound are generated when switching on or off.
b) Checking and setting the digital trimming
Before you can carry out setting work on your model or
start with the programming of your product, you must
ensure that the digital trimming for the steering and
drive function is set to the middle position (0).
Middle position of the steering function
Using the "TR2" trimming button for the steering func-
tion, set the middle position for the steering servo (ST).
To do this, press the "TR2" trimming button either to
the left or to the right in order to set the value to 0. If
you hold down the trimming button, the value will be
changed constantly.The value can be adjusted between
left and right at up to 30 steps each.
Every short operation of the programming and setting buttons is conformed by an acoustic signal with
the sound activated. If the button is held down longer, the values change constantly and the transmitter
sounds signals at a faster rate.
Middle position of the drive function
Using the trimming button (TR3) for the drive function, set the middle position for the gas servo (TH). To do this, press
the trimming button (TR3)either to the left or to the right in order to set the value to 0. If you hold down the trimming
button, the value will be changed constantly. The value can be adjusted between left and right at up to 30 steps each.
Every short operation of the programming and setting buttons is conformed by an acoustic signal with the
sound activated. If the button is held down longer, the values change constantly and the product sounds
signals at a faster rate.
Also set the middle value precisely if you are using an electronic cruise control in place of a gas servo.
Figure 4
55