Table des Matières
Publicité
Certifications
RG2
CE/EU Declaration of Incorporation (Original)
According to European Machinery Directive 2006/42/EC annex II 1.B.
The manufacturer:
OnRobot A/S
Teglværskvej 47H
DK-5220, Odense SØ
DENMARK
declares that the product:
Type:
Model:
Generation: V2
Serial:
may not be put into service before the machinery in which it will be incorporated is declared in
conformity with the provisions of Directive 2006/42/EC, including amendments, and with the
regulations transposing it into national law.
The product is prepared for compliance with all essential requirements of Directive 2006/42/EC
under the correct incorporation conditions, see instructions and guidance in this manual.
Compliance with all essential requirements of Directive 2006/42/EC relies on the specific robot
installation and the final risk assessment.
Technical documentation is compiled according to Directive 2006/42/EC annex VII part B and
available in electronic form to national authorities upon legitimate request. Undersigned is
based on the manufacturer address and authorized to compile this documentation.
Additionally, the product declares in conformity with the following directives, according to
which the product is CE marked:
2014/30/EU — Electromagnetic Compatibility Directive (EMC)
2011/65/EU — Restriction of the use of certain hazardous substances (RoHS)
Relevant essential health and safety requirements of the following EU directives are also
applied:
2014/35/EU — Low Voltage Directive (LVD)
2012/19/EU — Waste of Electrical and Electronic Equipment (WEEE)
A list of applied harmonized standards, including associated specifications, is provided in this
manual.
Budapest, December 16th, 2019
Industrial Robot Gripper
RG2
1000000000-1009999999
Group Management
Vilmos Beskid
CTO
224
Publicité
Table des Matières
