Stryker Power-PRO TL Manuel D'utilisation Et D'entretien page 55

USING THE OXYGEN BOTTLE HOLDER
To attach an oxygen bottle to the oxygen bottle holder:
1. Center the oxygen bottle on the cradled surface of item (A) as shown in Figure 34.
2. Tighten both straps (B) around the oxygen bottle.
3. Secure the slack on the straps and buckle both straps.
Note: Inspect the straps and buckles for wear between use and replace the strap if it is no longer holding the oxygen
bottle.
CAUTION
• To avoid damage to the oxygen bottle holder (if equipped), the weight of the equipment must not exceed 2.9 stones
(18 kg) (40 lb).
• Only use oxygen bottles which lie within the width of the cot and are large enough to be firmly held by the straps.
www.stryker.com
Optional Accessories
Figure 34: Oxygen Bottle Holder
6550-109-005 REV A
B
A
Return To Table of Contents
1-53
English