Installing The Push Bars - Stryker Power-PRO TL Manuel D'utilisation Et D'entretien

INSTALLING THE PUSH BARS

The optional push bars allow you to maneuver the cot at any
height position.
To install the push bars:
1. Insert each bar into one of the four corner sockets.
2. Push down until each locking mechanism is fully engaged
as shown in Figure 28.1.
WARNING
• Ensure that the push bar is properly locked into its mount
to prevent the bar from coming out during use and possibly
injuring the operator and/or patient.
• Do not lift the cot with the push bars. Lifting the cot by
the push bars may result in failure of the push bar lock
mechanism and may injure the operator and/or patient.
REMOVING THE PUSH BARS
To remove the push bars:
1. Press the red release button and lift each bar out of its
corner socket.
2. Place the removed push bars into the storage pouch that is
located on the base frame as shown in Figure 28.2.
WARNING
When not in use, store the push bars in the base storage pouch
that is provided with the push bar option.
ATTACHING THE PUSH BAR STORAGE POUCH
To attach the storage pouch:
1. Connect the corresponding buckles to secure the pouch to
the cot frame (A) as shown in Figure 28.3.
2. Ensure that the pouch and its contents do not interfere
with the cot operation before raising or lowering the cot or
transporting the cot.
www.stryker.com
Operation Guide
6550-109-005 REV A
Figure 28.1: Installed Push Bar
Figure 28.2: Stored Push Bar
A
Figure 28.3: Push Bar Storage Pouch
Return To Table of Contents
English
1-45