Using Restraint Straps - Stryker Power-PRO TL Manuel D'utilisation Et D'entretien

USING RESTRAINT STRAPS

WARNING
Always use all restraint straps to secure the patient
on the cot. An unrestrained patient may fall from
the cot and be injured.
Always secure the patient on the cot with all of
the restraint straps. Buckle the restraints across
the patient's chest/shoulders, waist and legs as
shown in Figure 20.1. Keep the restraint straps
buckled when the cot is not being used with a
patient to avoid damage to the buckles and straps.
WARNING
Do not attach restraints to the base or cross
tubes, improper restraint attachment could result in
damage to the cot further resulting in injury to the
patient or operator.
Figure 20.2: Head Section Restraints
To attach the patient restraint straps to the cot litter frame, feed the loop end of each strap through the litter frame at
each of the designated locations in Figure 20.2 and 19.3 and then feed the buckle or latch plate back through the loop
end of the strap. The arrows indicate alternate attachment areas.
When attaching the restraint straps to the cot, the attachment points should provide both strong anchorage and proper
restraint position while not interfering with equipment and accessories.
www.stryker.com
Operation Guide
Figure 20.1: Safety Restraints
Figure 20.3: Foot Section Restraints
6550-109-005 REV A
Return To Table of Contents
1-37
English