Engaging The Cot Into The Fastener; Operation Guide - Stryker Power-PRO TL Manuel D'utilisation Et D'entretien

English

ENGAGING THE COT INTO THE FASTENER

To engage the cot into the fastener:
1. Before attempting to engage the cot into the fastener, ensure that the pedal is fully depressed and the cot is
completely lowered as shown in Figure 5.
2. Guide the cot into both the head end and foot end of the fastener until the locking mechanism is engaged as
shown in Figure 6.
Figure 5: Pedal Fully Depressed
3. Make sure that the cot is securely fastened at both the head end and foot end before releasing your grip on the
cot as shown in Figure 7.
Figure 7: Cot in Fastener (Head End)
Return To Table of Contents
1-22

Operation Guide

Figure 6: Cot in Fastener - (Foot End)
CAUTION
• The unit must be in its lowest position to properly
engage the cot fastener (not included). To ensure that the
cot is in the lowest position, press the retract (-) button
until the cot stops moving down. This should be done
before attempting to engage the cot into the cot fastener
(not included).
• To reduce the risk of damage to the cot or cot fastener,
do not attempt to activate the cot height activation while it
is engaged in the cot fastener (not included).
6550-109-005 REV A www.stryker.com