Adjusting The Footrest - Stryker Power-PRO TL Manuel D'utilisation Et D'entretien

English

ADJUSTING THE FOOTREST

The footrest is adjustable to elevate the patient's legs as shown in Figure 25.
To raise the footrest, lift the footrest frame (A) as high as possible. The support bracket engages automatically when
released.
To lower the footrest, lift the footrest frame (A) and while holding the frame, lift up on the release handle (C) until the
bracket disengages. Lower the footrest until it is flat.
To raise the gatch, lift either of the red lifting loops (B) until the gatch is in its fully raised position, then slowly lower
the gatch to allow the support bracket to engage into the locking mechanism. Make sure that the lock is fully engaged
before releasing the lifting loop.
To lower the gatch, lift either of the red lifting loops (B) to relieve pressure on the locking mechanism and while holding
the loop, lift up on the red release handle (C) until the bracket disengages. Lower the gatch to the flat position.
Return To Table of Contents
1-42
Operation Guide
Figure 25: Footrest Elevated and Gatch Raised
6550-109-005 REV A
B
A
C
www.stryker.com