Passenger Seat Lock And Helmet Holder - Ducati MULTISTRADA 1000DS S Mode D'emploi

Passenger seat lock and helmet holder

Opening (fig. 28)
Insert the key into the seat lock (1) and turn it clockwise
until the seat hook disengages with an audible click.
Lift the rear of the seat (2) and slide it backwards off the
front mountings.
Closing
Fit the seat over the tank mountings and pull it backwards
until it engages.
Press down on the rear of the seat until you hear the lock
engage with an audible click.
Make sure the seat is fully engaged by gently pulling it
upwards.
The hook for the helmet holder cable is located under the
passenger seat. Pass the cable (A) through the helmet
and fit the ends of the cable into the hook. Leave the
helmet hanging on the left side (fig. 29) and refit the
seat to secure it.
Warning
This device protects the helmet against theft when
the motorcycle is parked. Do not leave the helmet attached
in this way when riding the motorcycle as it can interfere
with riding and cause loss of control of the motorcycle.
Hang the helmet cable from the left side of the
motorcycle. In any other position the cable will interfere
with the seat closure.
OPEN
1
A
E
fig. 28
fig. 29
39