Ipg Battery Status - Boston Scientific Precision Montage SC-1200 Mode D'emploi

Implantable Pulse Generator
• Charger Belt: Place the Charger into the pocket on the Charger Belt so that the Power button
is visible through the mesh fabric. Secure the Charger over the Stimulator by adjusting the
Charger Belt.
Note: If you accidentally locate the patch in the wrong place, or if the Charger Belt moves out of
alignment, the Charger will start beeping again. Use a new adhesive patch or readjust the belt to
place the Charger back into position.
5. When the Charger emits a series of double beeps, the Stimulator is fully charged. Turn off the Charger,
remove the Charger Belt or adhesive patch, and return the Charger to the Base Station. Do not
confuse the end of charge signal (a series of double beeps) with the continuous beeps that indicate
that the Charger is searching for the Stimulator.
Note: • The end of a charge signal is a distinct double beep, and the alignment indicator is a steady
continuous signal.
• The Remote Control will not be able to communicate with the IPG when charging.
Refer to "IPG Battery Life" in your Information for Prescribers manual for information on Stimulator battery
life.

IPG Battery Status

The patient Remote Control displays the Stimulator battery status when communicating with the
Stimulator. Refer to the Clinician's Remote Control Directions for Use for additional information. When the
Remote Control indicates a low battery the Stimulator should be recharged as soon as possible.
Failure to recharge may lead to loss of stimulation in less than 24 hours. After stimulation stops,
communication with the Stimulator will also cease. Until a sufficient level of charge has been attained, the
Stimulator may not communicate with the Remote Control.
Implantable Pulse Generator
91053242-08 Rev A 12 of 279
Production
Boston Scientific Confidential. Unauthorized use is prohibited.
Montage MRI IPG Entrada 2.0 19L
92070454 A.1
Page 16 of 284