SICAR Group Furore 300 I Manuel D'utilisation page 45

4.3 GUARDS, PROTECTION AND
SAFETY DEVICES
IMPORTANT
To protect against electrocution, the
machine must be earthed with cable
of adequate cross section.
With the machine at a standstill, to clean
or service internal parts always interrupt
power and indicate work in progress
(see fig.4.1).
To correctly store and use the various
tools, always wear leather gloves (see
fig.4.2).
IMPORTANT!
During machining operations, the
protection devices must not be removed
and the safety devices must not be
touched, changed or disengaged.
This will protect the operator and any
other person exposed to danger.
4.3.1 - PROTECTION DEVICES,
GUARDS AND SAFETY DEVICES
The machine features the following
protection devices, guards and safety
devices:
1 BRIDGE PROTECTION
for surface planing fig. 4.3.1C
2 CHIP EJECTOR HOOD
for thicknessing operations fig. 4.3.1B
3 SAW OPERATION PROTECTION
DEVICE
fig. 4.3.1E (description at chap. 4.3.4)
4 SPINDLE MOULDER PROTECTION
FOR WORKING AT FENCE
profiling fig. 4.3.1D - (description at
chap. 4.3.5)
5 SPINDLE MOULDER PROTECTION
FOR SPINDLE WORKING (CE/CSA)
fig. 4.3.1F contour routing - (description
at chap. 4.3.6)
6 MORTISER SPINDLE PROTECTION
fig. 4.3.1L - (description at chap. 4.3.7)
7 MICROSWITCHES INTERLOCKED
WITH TABLE OPENING (CE/CSA)
fig. 4.3.1G and fig. 4.3.1L - these are
located underneath the fulcrum where
rotation of the two surface planing tables
occurs
8 MICROSWITCH INTERLOCKED
WITH EJECTOR HOOD (CE/CSA)
fig. 4.3.1H - for thicknessing operation
9 MICROSWITCH INTERLOCKED AT
DOOR (CE/CSA)
fig. 4.3.1A - to access the spindle
moulder speed change
10 CONTROL PANEL EMERGENCY
BUTTONS (CE/CSA)
fig. 4.3.1M – positioned one on the front
for saw/spindle moulder operation and
one on the rear for saw and thicknessing
operation –
11 EMERGENCY BUTTON MORTISER
SIDE
fig. 4.3.1L - for surface planing and
mortiser operation
12 PULSATING OF EMERGENCY
SIDE THICKNESS
fig. 4.3.1B - for the thickness
workmanship
13 PADLOCKABLE MASTER SAFETY
SWITCH (CE/CSA)
fig. 4.3.1M - positioned on the control
panel
14 SWITCH FOR SELECTING THE
TYPE OF OPERATION
fig. 4.3.1M - positioned on the control
panel
59
Fig. 4.3.1B
Fig. 4.3.1C