Publicité
All manuals and user guides at all-guides.com
TIRE PRESSURE CHECK/SPOKES INSPECTION AND
TIGHTENING/WHEEL INSPECTION
EC36Q000
TIRE PRESSURE CHECK
NOTE:
EC36S002
SPOKES INSPECTION AND TIGHTENING
NOTE:
Be sure to retighten these spokes before and
after break-in. After a practice or a race check
spokes for looseness.
EC36T000
WHEEL INSPECTION
3 - 41
1. Measure:
Tire pressure
Out of specification → Adjust.
Standard tire pressure:
100 kPa (1.0 kg/cm
Check the tire while it is cold.
Loose bead stoppers allow the tire to slip off
its position on the rim when the tire pressure
is low.
A tilted tire valve stem indicates that the tire
slips off its position on the rim.
If the tire valve stem is found tilted, the tire is
considered to be slipping off its position. Cor-
rect the tire position.
1. Inspect:
Spokes 1
Bend/damage → Replace.
Loose spoke → Retighten.
2. Tighten:
Spokes
3 Nm (0.3 m · kg, 2.2 ft · lb)
1. Inspect:
Wheel runout
Elevate the wheel and turn it.
Abnormal runout → Replace.
INSP
ADJ
2
, 15 psi)
Publicité
