Preparing The Vehicle For The Alignment Operation; Standard Working Sequence - Corghi EXACT BlackTech X Plus Manuel D'utilisation

Customised logo for printout
The customer's logo can be added to the printed
job report.
Replace file C:\ Programs Files \Alignment\Graph-
ics\Image\IMGPrBarra4.bmp with an equivalent
containing the logo of your choice.
Warning! The file dimensions must be 1100 x
354 pixels.
PREPARING THE VEHICLE
FOR THE ALIGNMENT
OPERATION
For the wheel alignment operation to be carried
out correctly, all parts of the vehicle must conform
to the constructor's specifications; in particular,
it is important to check the tyre pressure and
eliminate any backlashes in the bearings and
ball joints.
Place the vehicle over the pit or on the lift
equipped for the alignment operations, taking
care to ensure that the turntables and oscillating
footboards are locked in position.
Fit the self-centring clamp/target assembly on
the wheels and lock the clamp jaws onto the
wheel rim using one of the two handles. Mount
the "vertical" targets on the front wheels and the
"horizontal" targets on the rear wheels (Fig. 27 B).
CAUTION
Do not over-tighten the clamp as this may
cause it to bend.
Operator's manual EXACT BlackTech X Plus
STANDARD WORKING
SEQUENCE
Alignment procedure for 2-axle vehicles (cars).
1) Aligner switch-on.
2) Start work.
3) Databank / Job record.
4) Preparation for wheel alignment.
5) Wheel diameter input.
6) Compensation.
7) Chassis height input.
8) Angle measurement with steering locked to
10° or 20°.
9) Data summary.
10) Rear axle measurement.
11) Front axle measurement.
12) Angle measurement with steering locked
to 10° or 20°.
13) Front axle measurement.
14) Print out of data measured.
(1) Switching on the aligner
IMPORTANT For the first start-up, the "Monitor
adjustment" chapter must be read.
Turn on the device using the main switch.
Wait a few seconds to allow the monitor to switch
on and the computer to load the program.
In this stage, the central unit runs a functional
self-diagnostics test and loads the operating
system; if everything is in order, the "Main menu"
screen will appear (Fig. 33).
If the user set-up field "Alignment customisation
procedure/Lift test" = YES, the programme will
automatically open the "Lift Check" page, see
"Lift and Target Check" section.
(2) Work start selection (Fig. 33)
Tilt level selection
Pressing ALT-O you access the page shown in Fig.
66, in which the current operator can be selected
by double clicking on the name.
Some icons are located at the bottom of the
screen that are used to set the camera tilting to
the preset levels:
Tilting reset and positioning to the fac-
tory predefined position.
Tilting positioning in the predefined
position for ROC.
Tilting positioning in the predefined
EN
61