Aligning Procedure Count; User File Backup - Corghi EXACT BlackTech X Plus Manuel D'utilisation

used to print, and to save the job done if you wish.
ends the session and sends the notifica-
tion that the order has been processed, and the
attached .XML file containing the data of the job
done to the Network Manager.
QUICK RADAR PROCEDURES
From the LOGO page, select the icons
and in succession to access the radar
adjustment page.
Cal One-Touch QUICK PROCEDURE
From the LOGO page, select the icons
and in succession to start the Cal One-
Touch quick procedure.
ALIGNING PROCEDURE
COUNT
The equipment now features a count of the
number of alignment jobs performed. The count
increases after performance of the ROC proce-
dure, including ROC skip.
To display the count, select the
and icons from the initial screen.

USER FILE BACKUP

From the logo page, select the icons
and , Fig. 56.
The page shown in Fig. 57 will open, allowing
you to select the backup or restore procedure
of the data regarding:
• The databank.
• Files of jobs carried out.
• Customer databank.
• Calibration log.
70
Backup procedure:
In the window shown in Fig. 57, select the icon
DATA SAVING. The page shown in Fig. 58 will
open, and here it is possible to set:
• The path for saving (HARD DISK, REMOVABLE
SUPPORTS, etc.).
• The frequency of the autosaves.
• Confirmation of the user before carrying out
the autosaves.
• Saving in compressed format.
Press Continue in order to proceed. The save
will be indicated as in Fig. 59.
The programme returns to the page shown in
Fig. 57. Click on the icon
the LOGO page.
Restore procedure:
In the window shown in Fig. 57, select the DATA
RESTORE icon. The page shown in Fig. 61 will
open, and here it is possible to select the path
leading to the data to be restored.
Once the correct path has been selected,
the data regarding the save are shown in the
lines below.
Press Continue in order to proceed. The indica-
tion of Fig. 62 will appear.
Press Continue to proceed with the restore, or
Cancel to cancel the operation.
Once the restore is completed, the indication
of Fig. 63 will appear, informing you to restart
the alignment programme in order to register
,
the data restore.
The programme returns to the page shown in
Fig. 57. Click on the icon
the LOGO page.
Operator's manual EXACT BlackTech X Plus
to go back to
to go back to