Corghi EXACT BlackTech X Plus Manuel D'utilisation page 60

➥ Chassis height before ROC
YES: The data related to chassis height is
entered before the ROC phase.
NO: The chassis height is entered after ROC.
➥ Ask to end the job
YES: A confirmation message is displayed if
the end of job icon is pressed.
NO: when the end of job icon is pressed, the
starting page will appear and any unsaved
data will be lost.
➥ Perform ROC
Always: ROC is always performed.
Manual skip: It is possible to skip the ROC
phase with the appropriate icon.
Automatic skip: ROC is always skipped.
➥ Push Mode ROC type
Professional: back to 60...then 30 then 0.
Standard: 30 - 0.
➥ Cal One-Touch
YES: Enables the Cal One-Touch device. Also
the connection port and the type of con-
nection should be enabled in the Assistant
Set-up.
NO: Disables the Cal One-Touch device.
➥ Steering wheel offset
YES: Displays the steering wheel centring
control page before the Cal One-Touch ad-
justment.
NO: Does not display the steering wheel cen-
tring control page before the Cal One-Touch
adjustment.
Wheel aligner
➥ Turntable enabling
Always: Electronic turntables for maximum
steering angle always enabled.
On request: Electronic turntables enabled
with the appropriate icon on the steering
page.
Never: Electronic turntables for maximum
steering angle not enabled.
➥ Axis of reference
Symmetry: axis of symmetry is axis of refer-
ence for both front and rear.
Thrust: thrust axis is axis of reference for both
front and rear. Setting the steering-wheel
with the front half toe values equal ensures
60
the steering wheel will be straight in normal
operating conditions. If the thrust axis is axis
of reference for the rear axle, the rear half toe
values area always identical.
Straight steering wheels: reference axis is axis
of symmetry for rear and thrust axis for front.
Setting the steering-wheel with the front half
toe values equal ensures the steering wheel
will be straight in normal operating conditions.
➥ Save previous data
Automatic: vehicle situation before adjust-
ment is saved automatically.
Manual: vehicle situation before adjustment
is saved manually.
➥ Caster measurement steering lock
20°: Steering always locked to 20° for caster
measurement.
User's choice: Caster measurement steering
lock at 10° or 20°.
➥ Front axle adjustment
Caster.
Total toe – setback.
➥ Rear axle adjustment
Total toe – thrust angle.
Setback – track difference.
➥ Thrust angle
Clockwise positive: angle is positive when
thrust axis is turned clockwise in relation to
the axis of symmetry.
Anticlockwise positive: angle is positive when
thrust axis is turned anticlockwise in relation to
the axis of symmetry.
The logo is the image shown as background in
the "Main Menu" (Fig. 33) and used as three-
dimensional image in the screen saver.
2 customised logos can be entered: they are
selected from the set-up as the "Customised 1"
and "Customised 2" logos.
The customised logo files must be in bitmap for-
mat and must have dimensions of 800x337 pixels.
Save the files in C: \ program files \ alignment \
graphics \ logo\.
The file for the "Customised 1" logo is LogoFeF.
bmp, for the "Customised 2" logo it is LogoFeW.
bmp.
Operator's manual EXACT BlackTech X Plus
Logo