JOB RECORD
From the printing stage, access the job record
using the
icon. Use of the job record
instead of selection of the vehicle from the da-
tabank can also be set in the set-up.
Another setting that can be made in the set-up
is the type of job record to be used.
Fill in the job record by using the keys as de-
scribed in the "DATABANK MANAGEMENT"
section.
The compulsory fields are highlighted.
WARNING
When a customer or vehicle is selected from
those already on file, the relative data are
loaded in the job record (e.g., when a vehicle
is selected by means of the registration num-
ber, the customer and the vehicle saved in
the vehicle record are automatically loaded).
These data overwrite those entered previously,
so the selected vehicle may be modified in the
databank.
When a new value is entered in the REG.N.,
CHASSIS and CUSTOMER fields, a new record
is automatically opened for data input.
When the job done is saved, the vehicle and
customer records are also automatically updated.
2-TARGET MODE
The following procedure allows you to align just
the front axle of the vehicle. It is recommended
for caravans or vans for which it is not possible
to mount the brackets and targets on the rear
axle, due to the fairing of the vehicle.
1) Mount only the front 2 targets.
2) Select the mode ROC and continue.
3) Make the steering.
4) Adjust the front axle.
5) If necessary, make the second steering.
6) Adjust the front axle.
7) The procedure is terminated on the Print page.
NOTE: the measurement in 2-target mode
does not guarantee that the steering wheel is
perfectly straight, as the rear axle reference is
not calculated.
68
MEASURING VANS /
CARAVANS
If parts of the bodywork are partially covering the
rear targets, the system is fitted with an automatic
detection function for such obstacles. The partial
covering is indicated on the compensation page,
by the appearance of the icon
Press this icon to continue with the measuring.
The system automatically compensates the
partial covering of the target and the measuring
continues in the normal way.
MEASUREMENT WITH
WHEELS RAISED
The "Measurement with wheel raised" procedure
allows the vehicle to be adjusted with two or four
wheels lifted off the ground.
Working in this position prevents the weight of
the vehicle applying force to the adjustment
registers, preventing their use.
From an axle (front or rear) adjustment screen,
activate the procedure by selecting
values measured are frozen and will not change.
Lift the vehicle and then select
measured data are available once more.
Adjust the data as in an ordinary alignment pro-
cedure; the values displayed will be the same
as those shown with the car "on the ground".
When the adjustment is complete select
. Select
adjustment screen. Lower and settle the vehicle.
Operator's manual EXACT BlackTech X Plus
.
; the
; the
to return to the normal