Corghi EXACT BlackTech X Plus Manuel D'utilisation page 66

WARNING
The mechanical turntables are required for
performance of the maximum steering angle
procedure.
(9) Data summary (Fig. 40)
Once the steering lock procedure is complete,
the system automatically moves on to display of
all the data measured. This function can other-
wise be accessed by selecting the
or the F5 key.
Vehicle's current situation. If the databank ref-
erence values are available, the values are dis-
played: on a red background if they are outside
the tolerance range, on a green background if they
are inside the range, on a dark blue background
if there are no reference values.
indicates that the angle is adjustable.
indicates that a help function is avail-
able for the adjustment.
The stylised vehicle illustrates, in an accentuated
way, the half toe, camber and setback situation.
saves the vehicle's pre-adjustment
values. The icon is only active if saving is set in
"Manual" mode in the set-up.
(10) Rear axle measurement
(Fig. 41)
To access this function from the rest of the pro-
gramme select the
Level the targets and adjust the angles by
bringing the values within the tolerance range
(numerical data and graph bar coloured green).
The 2 rear axle measurement screens display
the rear camber angle, rear half-toe, rear total
toe, thrust angle, rear set-back and track differ-
ence values.
In the rear axle measurement screen,
switches between the two pages of values.
cyclically displays only one value pair
at a time. In this phase, the angle symbol shows
66
icon
icon or the F2 key.
the real situation of the car.
normal display mode.
(11) Front axle measurement
(Fig. 23)
To access this function from the rest of the pro-
gramme select the
Level the targets and adjust the angles by
bringing the values within the tolerance range
(numerical data and graph bar coloured green).
The 2 front axle measurement screens display
the front caster, front camber, front half toe, front
total toe and front set-back angle values.
In the rear axle measurement screen,
switches between the two pages of values.
cyclically displays only one value pair
at a time. In this phase, the angle symbol shows
the real situation of the car.
normal display mode.
For adjustment of the caster the data, only avail-
able if the steering lock measurement procedure
has been carried out, must be on the screen.
The data are only shown when the front targets
are levelled.
N.B. On exit from this procedure the caster values
are saved automatically.
Saving of these values means that the procedure
can always be restarted from the last adjust-
ment made.
If a new steering lock procedure is performed, the
values recalled will be the last ones measured
during the steering lock sequence.
(12) Second angle measurement
with steering locked
Repetition of the steering axis angle measure-
ment allows you to check whether errors have
been introduced during adjustment of the caster.
The procedure is exactly the same as the first time
the caster, king pin and steering angle difference
values were measured.
Performing the steering lock procedure or
moves the programme straight on to
front axle measurement.
Operator's manual EXACT BlackTech X Plus
returns to
icon or the F1 key.
returns to