Corghi EXACT BlackTech X Plus Manuel D'utilisation page 64

(4) Preparation for wheel
alignment
Information for preparing the vehicle for check-
ing and adjustment of its wheel alignment in
accordance with the manufacturer's instructions.
The programme step is automatically activated
if this information is in the databank.
(5) Diameter input (Fig. 35)
To access this function from the rest of the pro-
gramme select the
The step is only active if it is set in the set-up or
operation with toe values in units of length has
been selected.
Set the rim diameter of reference to work with
toe values in millimetres or inches.
reference rim diameter stated in da-
tabank rim diameter set by the operator.
and
values in a pre-set list.
to do the job in angle measurements.
The angle unit of measurement selected in the
set-up will be set.
(6) Compensation (Fig. 36)
Runout compensation or ROC is used to com-
pensate any geometrical errors in the rim (runout
and plane error) and errors in fitting the clamps.
The compensation skip option is available if set
in the set-up.
Apply ballast to the vehicle as instructed and
select the RUNOUT compensation method
required.
The screen shows the databank references for
the selected vehicle.
indicates that the angle is adjustable.
indicates that a help function is avail-
able for the adjustment.
Complete display of the databank values is avail-
able in the DATABANK DATA SUMMARY
The values which depend on input of the chassis
height values are only shown after these values
64
icon or the F10 key.
scroll through the diameter
have been entered.
The compensation procedure is guided by means
of graphics showing the status or the operations
to be performed on each single target.
Standard Push Mode ROC (can be set from
Setup-Alignment mode)
Select the
dure, you must mount the 4 targets.
1) Place the vehicle on the lift or above the pit
with the front wheels straight and clamp the
steering wheel with the steering clamp.
2) Mount the targets on the wheels, blocking
the brake.
3) Follow the indications shown on the screen.
4) Move the vehicle backwards so that the
wheels complete a 30° rotation.
5) Move the vehicle forward to the initial posi-
tion.
6) If the final position values are too different
from the initial values, a procedural error is
signalled.
Professional Push Mode ROC (can be set from
Setup-Alignment mode)
This procedure allows you to eliminate the influ-
ence of the vehicle's mechanical play.
Select the
dure, you must mount the 4 targets.
1) Place the vehicle on the lift or above the pit
with the front wheels straight and clamp the
steering wheel with the steering clamp.
2) Mount the targets on the wheels, blocking
the brake.
3) Follow the indications shown on the screen.
4) Draw the vehicle back, so that the wheels
complete the angle rotation shown on the
screen.
5) Move the vehicle forward to the intermediate
position, with the angle shown on the screen.
6) Move the vehicle forward to the initial posi-
tion.
7) If the final position values are too different
from the initial values, a procedural error is
signalled.
NOTE: if the stopping positions (shown on the
.
screen) are exceeded, it is necessary to repeat
the previous step of the procedure, as shown
on the screen.
Operator's manual EXACT BlackTech X Plus
icon. To activate the proce-
icon. To activate the proce-