Upgrading The Wheel Aligner Software; Enabling Extra Wheel Aligner Functions; Installation Space - Corghi EXACT BlackTech X Plus Manuel D'utilisation

Upgrading the wheel aligner
software
The wheel aligner is supplied with the software
already installed, and is complete with an instal-
lation DVD-ROM.
After installing the wheel aligner, switch on the
machine and go to the starting screen.
Press the key combination È + F12 (upper case
+ F12): the software version will appear on the
top left of the screen, beneath the CORGHI logo.
Compare the software release (indicated as "SW
STD ...") with that stated on the installation
DVD-ROM supplied with the aligner.
If the DVD-ROM release is more recent than the
release installed, update the aligner software.
Detailed information about the software update
procedure is provided in the leaflet accompany-
ing the DVD-ROM.
Enabling extra wheel aligner
functions
Extra wheel aligner functions are enabled by
upgrading the main protection SIM CARD.
Upgrading is performed with the "Upgrade
SIM CARD" obtained by ordering the relative
accessory kit.
Upgrade cards carry specific identification
symbols; detailed information on upgrade
identification is supplied in the leaflets which
accompany them.
To upgrade the main protection card, run the
relative procedure with the icons
and
prompts. You will be asked to remove the main
Hard Lock SIM CARD and insert the upgrade SIM
CARD. After the procedure, the main SIM CARD
must be reinserted.
The upgrade SIM CARD cannot be reused. Ho-
wever, keep it for use if it becomes necessary to
reprogram the main card of the wheel aligner for
which it was used the first time.
The ,
the system configuration:
CARD: card number 1 is the wheel aligner's main
card; card number 2 (if any) is an update card.
HEADER: "MAS" aligner main card, "AGG"
update card.
44
and follow the on-screen
and icons display
SERIAL: card serial number. For main cards
this number is unique. For update cards the
number is 0 when they are new, while after use
it becomes the same as that of the main card
that has been updated.
DATE: card creation date.
VAS: "ON" VW/AUDI programme on, "OFF"
programme off.
MLK: "ON" MULTILINK suspension car pro-
gramme on, "OFF" programme off.
REN: "ON" RENAULT programme on, "OFF" pro-
gramme off The RENAULT programme reverses
the toe signs for RENAULT vehicles only.
MER: "ON" MERCEDES programme on, "OFF"
programme off.
PHEATON: "ON" VW Phaeton and Touareg pro-
gramme on, "OFF" programme off.
ANIM: "ALL" display of alignment adjustment
help animations on, "FIN" display of non-moving
alignment adjustment help diagrams, "OFF"
alignment adjustment help graphics off.
ROMESS: "ON" ROMESS CM-09606 inclinometer
automatic connection programme on, "OFF"
programme off.
ASANTW: "ON" ASA Network programme on,
"OFF" programme off.
RADAR: "ON" vehicle anti-collision radar calibra-
tion programme on, "OFF" programme off.
CUSTOM: type of wheel aligner customisation.
BD YEAR: year of the latest databank update, if
"DEMO" the aligner card has not been inserted
,
or is not functioning correctly.

Installation space

WARNING
Choose the place of installation in strict obser-
vance of local regulations regarding safety in
the workplace.
The floor must be able to withstand a load
equal to the sum of the weight of the equipment
itself and the maximum payload, bearing in
mind the lift support surface area and anchor
fixtures used.
Place the aligner in the designated work position
and make sure that the rear panel of the equip-
ment is at least 10cm away from the nearest wall.
IMPORTANT: for correct, safe use of the equip-
Operator's manual EXACT BlackTech X Plus