Publicité
Les langues disponibles
Les langues disponibles
System requirements and recommendations for iBed Wireless (option)
(Continued)
Customer network communication requirements for iBed Wireless option
LAN environment
Client/server communication
Client device IP allocation
Server IP allocation
VLAN
IP traffice environment
Source
iBed Server
iBed Server
iBed Server
Third party / Stryker iBed Wireless
Client
Customer WLAN environment
Supported wireless vendors
Access point (AP) types
Channel width
www.stryker.com
Introduction
IPv4 only
Static
DHCP
Static IP required
New, existing
Protocol / Port number
TCP/21
TCP/80/443
TCP/1639
TCP/80/443
Cisco, Aruba
Controller-based or autonomous
2.4 GHz: 20 MHz
5 GHz: 20/40 MHz
3005-009-005 REV A
Not applicable
•
If Static - Unique IP address will
be required for each client MAC
address
•
If DHCP and not using a DNS
name - Each client MAC address
will need a reserved IP address
•
If DHCP and using a DNS name -
It is required to create a unique
name for each client MAC
address for client management
– Stryker recommends using
the Stryker client host name
when the Stryker device
connects to the wireless
network - Example: SYK-
00197b12365 so it may look
like http://SYK-00197b12365.
hosp.org
Not applicable
Install iBed Wireless on a separate
VLAN
Destination
Stryker iBed Wireless Client
Third party / Stryker back office
Stryker iBed Wireless Client
iBed Server
Required
Yes
Yes
Yes
English
EN
1-11
Publicité
