Publicité
Les langues disponibles
Les langues disponibles
Footboard control panel - Scale (Continued)
2.
Release the Scale button.
Note: Do not touch the product when you weigh the patient
A confirmation notification indicates that weighing the patient was successful
Note: To clear the patient weight from the display, press the Scale button again. The patient weight is still recorded in
the weight log.
Notes
•
Always calibrate the bed after adding a support surface or mattress to the bed frame.
•
Always set the scale to zero before putting a patient on the product.
Setting the scale to zero
The zero function clears all of the stored values from the weight log, change patient weight, and gain or loss.
Note: Always set the scale to zero before putting a patient on the product.
To set the scale to zero:
1.
Press and hold the Zero button (B) (see
until the Release Button appears
Figure 1-28: Hold to zero
www.stryker.com
Operation
(Figure 1-26 on page
Figure 1-26: Do not touch bed
Figure 1-27: Patient weight
Footboard control panel - Scale on page
(Figure 1-29 on page
1-41).
3005-009-005 REV A
1-41).
(Figure 1-27 on page
1-41).
1-40)
(Figure 1-28 on page
Figure 1-29: Release Button
English
EN
1-41)
1-41
Publicité
