Stryker S3 MedSurg Manuel D'utilisation page 22

Setup
English
Equipping the optional nurse call communication (Continued)
EN
To activate the optional nurse call communication, see Activating nurse call communication (option) on page 1-26.
A
B
Figure 1-3: Nurse call pendant port and 37-pin connector
Setting up the optional iBed Wireless
WARNING
Always associate or map the iBed Locator to the room or location to provide accurate location information. Failure to
properly associate or map the iBed Locator to the room or location will yield incorrect remote information. If you move
an iBed Locator after it has been installed and mapped, you must remap to the new room or location. If the room or
location information is changed after initial installation, you must remap the iBed Locator.
To setup your product to receive a wireless connection, you must install the iBed Locator on the wall at the head end of
the product. The iBed Locator communicates with the IR module that is installed in your product. For detailed
instructions about how to mount the 5212 iBed Locator, see the instructions for use that was included with your optional
5212 iBed Locator installation kit.
Contact Stryker Technical Support at (800) 327-0770 with any installation questions.
Note:
You must load the wireless connection settings before the device will communicate with the iBed Server application.
See the iBed Server Installation and Configuration manual.
1-16 3005-009-005 REV A www.stryker.com