Publicité
Les langues disponibles
Les langues disponibles
English
Arming or disarming Chaperone bed exit with zone control (option) (Continued)
EN
To arm bed exit:
1.
Set the scale to zero. See
Note: If you do not set the scale to zero before placing a patient on the product, bed exit may not operate properly.
2.
Position the patient on the product.
3.
Press and hold the Arm/Disarm button (D). See
(option) on page
Note: Zone 1 illuminates as the default zone when you arm Chaperone bed exit.
4.
To change the zone, press the Zone button (E). See
control (option) on page
After arming Chaperone bed exit, the LED light bars on the footboard illuminate green, the bed exit indicator LED on the
footboard LED indicator illuminates, and the selected zone on the footboard control panel illuminates.
If the patient moves from the armed zone and changes the bed exit parameter:
•
LED light bars on the footboard flash amber
•
bed exit indicator LED on the footboard LED indicator flashes
•
sound alarm is triggered
•
selected zone on the footboard control panel flashes
•
status alert is displayed on the display screen
To disarm bed exit, press and hold the Arm/Disarm button again (D). See
with zone control (option) on page
Footboard LED indicators
B
A
C
D
Indicator
A
Bed motion lock
B
Fowler 30°+
C
Patient control Fowler lock
1-38
Setting the scale to zero on page
1-37.
1-37.
1-37.
E
Figure 1-23: Footboard LED indicators
Operation
1-41.
Footboard control panel - Chaperone bed exit with zone control
Footboard control panel - Chaperone bed exit with zone
Footboard control panel - Chaperone bed exit
F G H
LED illuminates amber
Bed motion lock is activated or when the patient
control (Fowler, gatch, bed up/down) lock buttons
are activated
Fowler 30°+ is locked. The LED will blink amber if:
•
iBed Awareness system is on
•
Fowler 30°+ is being monitored and the Fowler
goes below 30 degrees
•
Fowler 30°+ is turned off
The patient control Fowler lock is on
3005-009-005 REV A
www.stryker.com
Publicité
