Publicité
Les langues disponibles
Les langues disponibles
Operation
English
Activating nurse call communication (option) (Continued)
EN
Note: A 9V battery, located in the head end of the product, powers the nurse call signal. If the product is unplugged
from a wall outlet while the nurse call pendant port switch is set to the on position
(Figure 1-17 on page
1-27), the
charge of the 9V battery will begin to drain.
If the 9V nurse call battery needs to be replaced, a message will appear on the footboard display. See
Replacing the
nurse call backup battery (option) on page
1-27.
Figure 1-17: Nurse call switch
Replacing the nurse call backup battery (option)
To prevent a low battery condition when the bed is not plugged in, position the cord out switch at the head end of the
bed to the off position. If the switch is not positioned as shown below (A)
(Figure 1-18 on page
1-28) and the bed power
cord and pendant cord are unplugged, the life of the backup battery will be significantly reduced.
www.stryker.com
3005-009-005 REV A
1-27
Publicité
