Publicité
Les langues disponibles
Les langues disponibles
English
Installing the patient restraint strap tie-ins (Continued)
EN
There are eight patient restraint strap tie-in locations on the litter assembly for installing patient restraint straps. Two are
located on the Fowler section, two are located on the seat section, and four are located on the foot section
on page
1-22).
Raising the siderails
WARNING
•
Always set the siderail position to make sure that a patient is safely in the product.
•
Always lock the operator control panel and patient control panel when the patient is unattended.
•
Always keep the siderails outside of the oxygen tent.
Note: Do not use siderails as a patient restraint device.
When raising the siderails, listen for the click that indicates that the siderail has locked into position. Pull on the siderail
to make sure that it is locked.
To raise the siderail to its highest position, grasp the release handle and rotate the siderail toward the head end of the
product
(Figure 1-11 on page
Note: The siderail does not lock into the intermediate position when you raise the siderail.
1-22
Operation
Figure 1-10: Restraint strap tie-in locations
1-23).
3005-009-005 REV A
(Figure 1-10
www.stryker.com
Publicité
