Stryker S3 MedSurg Manuel D'utilisation page 52

English
Measuring weight gain or loss (Continued)
EN
4. Release the Enter button.
Note: Do not touch the product when you measure weight gain or loss
A confirmation notification indicates that enabling Gain/Loss was successful.
The base measurement is the initial patient weight registered when you enable Gain/Loss. The weight difference
between the base weight and the weight gained or lost is displayed on the bottom right hand corner
page 1-46).
Note: If the weight gained or lost exceeds 99.9 lb., Error –.- appears on the display
To disable gain or loss:
1. Press the Menu button (A). See
2. Scroll to Gain/Loss.
3. Press and hold the Enter button (F). See
Changing equipment
Change equipment allows you to add or remove equipment or devices from the product without affecting the patient
weight.
To change equipment:
1. Press the Menu button (A). See
1-46
Operation
Figure 1-39: Do not touch bed
Figure 1-40: Base and gain/loss weight measurement
Figure 1-41: Gain/loss error
Figure 1-33 on page 1-43.
Figure 1-33 on page
Figure 1-33 on page 1-43.
3005-009-005 REV A
(Figure 1-39 on page
(Figure 1-41 on page
1-43.
1-46).
(Figure 1-40 on
1-46).
www.stryker.com