Keysight 53210A Mode D'emploi page 89

The MEASure and CONFigure Commands
Each time the counter takes a measurement it does so from a configuration
based on multiple parameters. The easiest and most common starting point for
setting these parameters programmatically is using commands within the
CONFigure
commands as multiple counter parameters are set or defaulted from a single
command. "Low-level" commands are those within other subsystems (i.e.
TRIGger
defaulted to, using
Executing commands from the
to setting parameters individually using the commands/subsystems shown in
Table
Keysight 53210A User's Guide
and subsystems. These commands are considered "high-level"
MEASure
, ) that allow you to change a parameter value from that set, or
SENSe
CONFigure
3-2.
or .
MEASure
and
CONFigure MEASure
53210A Measurements
subsystems is equivalent
3
,
INPut
89